Add a Line with a Fixed Angle
This mode allows a line to be constructed with a fixed numerically given angle to another line. The new line and a point through which it should pass can be added with a press–drag–release sequence. The point through which the new line should pass can also be generated with this mode.
When you select this mode, the property inspector pops up, asking you to specify the desired angle.
Otherwise, the use of this mode is analogous to add a parallel mode.
This mode creates a line with fixed angle with respect to another line with a press–drag–release sequence.
The definition of angle depends on the chosen geometry.
The content on this page is licensed under the terms of the License.